Re: Re [LI] Help: Drivers for Compaq Proliant 1600

[Rupesh Nadar <rupesh@xxxxxxxxxxxxxx>]

I have done an installation on Compaq Proliant 1200, Redhat 6.0 did pick
up the cards quite smoothly, I cannot recollect correctly, but I think I
had a similar problem trying to install RH 5.2.

I'm sure RH 6.0 shouldn't be a problem.

-Rupesh

On Fri, 17 Dec 1999, K K Pareek wrote:

> We are using RHL 6.0 on our Proliant 5000 for quite some time. The network
> card is on board same as yours. The installation detects it too. Why do not
> you try RHL 6.0 instead of RHL 5.2.
> 
> K K Pareek, J K Cement Works, PO- NIMBAHERA, Raj-312617
> E-mail: kkpareek@xxxxxxxx
> 
> >Am installing Red Hat 5.2 (Old is Gold !!) on a Compaq Proliant 1600
> > machine. But it is unable to probe any network card that comes listed
> > with it while installation.
> >
> > Compaq site too is of little help. I can't even figure out what Network
> > card they use:
> > This is what they say: Compaq Netelligent 10/100 TX UTP Controller on
> > the PCI local bus
> >
> > Does anybody have any experience to enlighten us!!!!
> >
> > Warm regards,
> > Kimi
> 
> 
> 
> --------------------------------------------------------------------
> The Linux India Mailing List Archives are now available.  Please search
> the archive at http://lists.linux-india.org/ before posting your question
> to avoid repetition and save bandwidth.
> 


--------------------------------------------------------------------
The Linux India Mailing List Archives are now available.  Please search
the archive at http://lists.linux-india.org/ before posting your question
to avoid repetition and save bandwidth.