Re: Returned mail: Service unavailable

[Neil <neil@xxxxxxxxxxxxxxx>]

Mail Delivery Subsystem wrote:

> The original message was received at Mon, 11 Sep 2000 12:47:46 +0530 (IST)
> from IDENT:root@[203.94.247.120]
>
>    ----- The following addresses had permanent fatal errors -----
> <linux_delhi@xxxxxxxxxxx>
>
>    ----- Transcript of session follows -----
> ... while talking to mc2.law5.hotmail.com.:
> >>> MAIL From:<neil@xxxxxxxxxxxxxxx> SIZE=1403
> <<< 554 Transaction failed
> 554 <linux_delhi@xxxxxxxxxxx>... Service unavailable
>
>   ------------------------------------------------------------------------
> Reporting-MTA: dns; delhi1.mtnl.net.in
> Received-From-MTA: dns; [203.94.247.120]
> Arrival-Date: Mon, 11 Sep 2000 12:47:46 +0530 (IST)
>
> Final-Recipient: rfc822; linux_delhi@xxxxxxxxxxx
> Action: failed
> Status: 5.0.0
> Remote-MTA: dns; mc2.law5.hotmail.com
> Diagnostic-Code: smtp; 554 Transaction failed
> Last-Attempt-Date: Mon, 11 Sep 2000 12:48:31 +0530 (IST)
>
>   ------------------------------------------------------------------------
>
> Subject: Re: [linux-delhi] help!
> Date: Mon, 11 Sep 2000 12:40:14 +0600
> From: Neil <neil@xxxxxxxxxxxxxxx>
> To: chetan dutta <linux_delhi@xxxxxxxxxxx>
> References: <F66GE5oHKoFz6Tt6Zpy000027fe@xxxxxxxxxxx>
>
> > Hi Neil,
> >
>
> and hi 2 u  and all... i am finally out of the mtnl-less age....
> my fone lines to all digital nos(mtnl internet service..., mantra) were down
> due to the mtnl strike... and so now i am finally online!!!!
> yippee!!!!
>
> >
> > thanx  for your help, pleaseeeee....... mail me the algo.
> >
>
> well there is actually nothing much!
> all u gotta go is let va_lists take your floats in the form of char*'s ....
> then when actually using those values... all u gotta do is convert them using
> "variable=atof(va_arg value);"
> then variable has the value previously saved as ascii, in float form....
>
> >
> > i want to set up a dial in server, so that my friends could dial in to
> > my machine. i know mgetty is used for this purpose but don't know how,
> > also i want to allocate them ip address dynamically.
>
> actually... why dont u just use minicom....  and if u want to use ppp, just
> configure pppd properly and start it after the connection is established!
> it does all the authentication etc... and after that u hav a ppp connection
> between the two computers....
> its not the most advanced formula... but its simple and it gets the job done.
>
> > ...have to say pleaseeeeeeee....... for this also?
> >
>
> absolutely not!
>
> >
> > btw have any idea a'out next meet?
>
> buddy... it just passed us by!