Re: kernel 2.2.14 not recognising devices

["Sandeep Sundaram" <sandysundaram@xxxxxxxxxxxxxxx>]

Hai Kedar!
           I did what all U mentioned but still it could not see the
ethernet cards.
Following are the steps I followed:
   1)  make mrproper
    2) make xconfig
    3) make dep
    4) make clean
    5) make bzImage
    6) make modules
    7) make modules_install
    8) cp bzImage to /boot
    9) cp System.map /boot/System.map-2.2.14
   10) Link to System.map


Is there any mistake in above set of commands!!

TIA,
bye
Sandeep Sundaram
-------------------------------------------
Original Message
From: "Kedar Patankar"<kedar@xxxxxxxxxx>
Subject: Re: [LIP] kernel 2.2.14 not recognising devices
Date: Wed, 12 Apr 2000 15:55:09 +0530 (IST)

>> Unresolved symbols".
>> for eg. when I say "insmod 8390", it says " Unresolved symbol
>> disable_irq_nosync"
>
>	Did you do a make modules followed by make modules_install???
>Methinks you just check whether you have a directory /lib/modules/2.2.14.
>If you don't then you most likely haven't done
>make modules
>make modules_install
>	So just cd to the top level dir where you unpacked the kernel
>sources (normally /usr/src) and do the two "makes" above, and then just
>try insmoding your ethernet drivers. It should fix the problems.
>
>	Kedar.
>----------------------------------------------------------------
>Kedar N. Patankar.
>Senior Software Engineer.
>Ishoni Networks India Pvt. Ltd.
>Bangalore.
>email - kedar@xxxxxxxxxx
>----------------------------------------------------------------
>Don't worry over what other people are thinking about you.
>They're too busy worrying over what you are thinking about them.
>
>
>
>-----------------------------------------------------------------------
>For information on this and other Linux India mailing lists check out
>http://lists.linux-india.org/
>

_____________________________________________
Free email with personality! Over 200 domains!
http://www.MyOwnEmail.com