[LI] unable to setup eth0 interface

["rahul nanda" <r_nanda@xxxxxxxxxxxx>]

hi,
I have installed RH 6.1 from the PCQ cd. I am unable to set up the eth0 interface.
I have a ReadyLink 2000(COMPEX) card. When I use the netcfg program to configure eth0, I find that after exiting the eth0 interface becomes inactive.
WHY DOES THIS HAPPEN? I always make the interface active, save and then exit , but still this problem persists.
Using the linuxconf, in the basic host configuration menu, I set the kernel module as ne2k-pci.
I set IRQ as 10 and I/O as 0x300.
But when I type ifconfig to see the interfaces setup, I see no entry for
eth0. WHY IS THIS HAPPENING?
Please help...
Rahul Nanda


Get your FREE Email at http://mailcity.lycos.com
Get your PERSONALIZED START PAGE at http://my.lycos.com
--------------------------------------------------------------------
The Linux India Mailing List Archives are now available.  Please search
the archive at http://lists.linux-india.org/ before posting your question
to avoid repetition and save bandwidth.