[Subject Prev][Subject Next][Thread Prev][Thread Next][Subject Index][Thread Index]

RE: eth0 error



make sure that the bus is terminated correctly (terminators at each end of
the BNC backbone).

Atul

> -----Original Message-----
> From: Majordomo [mailto:majordom@xxxxxxxxx]On Behalf Of Indranil Das
> Gupta
> Sent: Friday, July 30, 1999 3:28 PM
> To: linux-india@xxxxxxxxx
> Subject: Re: eth0 error
>
>
> Atul,
>
> Suppose one has to connect using a BNC coax (bus topology) what
> does one do
> in such a case?
>
> --Indra.
>
> ----------
> From: Atul Chitnis <achitnis@xxxxxxxxxxxxxxxx>
> To: linux-india@xxxxxxxxx
> Subject: RE: eth0 error
> Date: Friday, July 30, 1999 2:45 PM
>
> You are not connected to a hub, and the card is complaining (which is
> hardly
> surprising).
>
> Until you connect to a hub, do an "ifconfig eth0 down".
>
>
> --------------------------------------------------------------------
> For more information on Linux in India visit http://www.linux-india.org/
> The Linux India mailing list does not accept postings in HTML format.
>
>


- --------------------------------------------------------------------
For more information on Linux in India visit http://www.linux-india.org/
The Linux India mailing list does not accept postings in HTML format.

------------------------------